4- 4 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Summary
Series
Resistor
SSR Sets the SMU series resistor of the specified channel to ON or OFF.
Filter FL Sets the filter of the specified channels to ON or OFF.
Integration
Time and
Averaging
AV For the E5260 series and the high-speed ADC of the E5270B. Sets the
number of samples for averaging of the ADC (A/D converter).
WAT Sets the source wait time and the measurement wait time.
AAD Only for E5270B. Selects the type of ADC, high-speed or high-resolution
ADC.
AIT Only for E5270B. Selects the number of samples for averaging or the
integration time of the ADC.
AZ Only for E5270B. Enables or disables the ADC zero function.
Output Data FMT Specifies the measurement data output format and the data terminator.
BC Clears the E5260/E5270 output data buffer that stores measurement data
and/or query command response data.
Source Setup DI Forces current from the specified channel.
DV Forces voltage from the specified channel.
High speed
spot
measurement
TI Executes the current measurement, and returns the measured data.
TV Executes the voltage measurement, and returns the measured data.
Time Stamp TDI Forces current (TDI) or voltage (TDV), and returns the time data from
when the timer is cleared until source output is started.
TDV
TSC Enables the time stamp function for the MM 1, 2, 3, 4, 5, or 16 mode.
TSQ Returns the time data from when TSR is given until TSQ is given.
TSR Clears the timer count.
TTI Measures current (TTI) or voltage (TTV), and returns the measurement
data and the time data for the time from when the timer is cleared until the
measurement is started.
TTV
Measurement
Mode
MM Sets the measurement mode and measurement channels.
Category Command Summary
To Next Page
Loading...
Need help?
General
