4- 6 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Summary
Binary
Search
Measurement
Setup
BSM Sets the source output control mode and the automatic abort function.
BST Specifies the hold time and delay time.
BSVM Selects the data output mode.
BSI Sets the current source channel.
BSSI Sets the synchronous current source channel.
BGV Sets the voltage monitor channel.
BSV Sets the voltage source channel.
BSSV Sets the synchronous voltage source channel.
BGI Sets the current monitor channel.
Linear Search
Measurement
Setup
LSTM Specifies the hold time and delay time.
LSVM Selects the data output mode.
LSI Sets the current source channel.
LSSI Sets the synchronous current source channel.
LGV Sets the voltage monitor channel.
LSV Sets the voltage source channel.
LSSV Sets the synchronous voltage source channel.
LGI Sets the current monitor channel.
LSM Sets the automatic abort function.
Measurement
Setup
CMM Sets the SMU measurement operation mode.
RI Specifies the current measurement ranging mode for measurement other
than the high speed spot measurement that uses TI/TTI command.
RV Specifies the voltage measurement ranging mode for measurement other
than the high speed spot measurement that uses TV/TTV command.
RM Sets the range selection rule for the auto ranging current measurement.
Internal
Variabl e
VA R Sets the value to the internal variable.
VA R? Returns the value set to the internal variable.
Category Command Summary
To Next Page
Loading...
Need help?
General
