EasyManuals Logo

Keysight Technologies E8257D User Manual

Keysight Technologies E8257D
417 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #394 background imageLoading...
Page #394 background image
404 E8257D/67D, E8663D PSG Signal Generators Service Guide
Post–Repair Procedures
Post–Repair Procedures Matrix
High Band ALC Modulator Calibration X
Low Band ALC Modulator Calibration X
IQ Gain/Offset/Quadrature Calibration X
Target IQ Power Calibration X X
1/f Corner Calibration X
IQ Time Skew RF X X
IQ Time Skew Baseband XX
ALC Dynamic Calibration X X X X
Upconverter Gain Adjustment Calibration X
High Band Power Flatness Calibration X X X X X
Low Band Power Flatness Calibration XXXXX
V-Band Power Flatness Calibration X X X X X
V-Band Low Power Attenuator Accuracy Calibration XX
Low Power Attenuator Accuracy Calibration X X
Lowband Filter Offset Calibration X
IQ Power Floor Calibration X X
Low Band IQ Power Floor Calibration
ALC Modulator Calibration X
ALC Mod Bias DAC Sensitivity Calibration XXX
AM Gain Calibration X
IQ Impairment Calibration X
Pulse Width Calibration X
Attenuator Cycle Count Reset (Service Software - Utility) X
Table 4-4 Post-Repair Adjustments: Assemblies A1—A11 (For prefixes >= xx4928)
Adjustments Replaced Assembly
The following adjustments are listed in the order that they should
be performed for proper calibration.
A1 Keyboard
A2 Display
A2DS1 Display Backlight
A3 Power Switch
A4 Inverter
A5 Sampler
A6 Frac-N
A7 Reference (Standard)
A7 Reference (Option UNR/UNX)
A8 Output (Analog)
A8 Output (Digital)
A9 YIG Driver
A10 ALC
A11 Pulse/Analog Mod Gen
ADC Calibration X X X X X X X X X
YIG–Driver Pre–Tune Calibration X
VCO Bias Frac–N Calibration X
Internal Source Cal (E8257D/E8663D with Option UNT) X
AM Audio Path Offset Cal (E8257D/E8663D with Option UNT) X
KV vs. Frequency Calibration X
Table 4-3 Post Repair Adjustments:
Assemblies A27—A40, AT1, B1, and RF Output Connector (For Prefixes <
xx4928) (Continued)
Adjustments Replaced Assembly
The following adjustments are listed in the order that they
should be performed for proper calibration.
A27 40 GHz Doubler
A28 YIG Oscillator
A29 20 GHz Doubler
A30 Mod Filter
A31 Motherboard
A32 10 MHz Crystal Oscillator
A34 Internal Hard Drive
A35 3 20 IQ Modulator
A36 Quadraplier
A37 Up Converter
A38 Lowband Switch Filter
A39 Directional Coupler
A40 Flash Drive
AT1 115 dB Attenuator
B1 Fan
RF Output Connector

Table of Contents

Other manuals for Keysight Technologies E8257D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight Technologies E8257D and is the answer not in the manual?

Keysight Technologies E8257D Specifications

General IconGeneral
BrandKeysight Technologies
ModelE8257D
CategoryPortable Generator
LanguageEnglish

Related product manuals