3 Getting Started
48 Keysight N6700 User’s Guide
Using the Front Panel Menu
The front panel command menu lets you access most of the power
system’s functions. The actual function controls are located at the lowest
menu level. Briefly:
Press the
key to access the command menu.
Press the navigation keys to move across the menu commands.
Press the center (
) key to select a command and move down to
the next level in the menu.
Press the
key at the lowest menu level to display help
information about the function controls.
A map of the front panel command structure is found in Chapter 1. The
following example shows you how to navigate the front panel command
menu to program the over-voltage protection function.
Set the Over-Voltage Protection
The over-voltage protection function turns off the affected output if the
output voltage reaches the programmed over-voltage limit.
Press
to access the front panel command menu. The first line
identifies the output channel that is being controlled followed by the
menu path. Since the top level is displayed, the path is empty.
The second line indicates the commands that are available at the
present menu level. In this case, the top-level menu commands are
shown, with the Output command highlighted.
The third line indicates which commands are available under the
Output command. Selecting the highlighted command accesses this
lower level.
Press the right arrow key to traverse the menu until the Protect
command is highlighted. Press
to select the Protect command.
The menu path now shows that the commands shown on the second
line are located under the Protect command. The OVP command is
highlighted. The third line indicates which functions are located under
the OVP command. Press
to select the OVP command.
To Next Page
Loading...
Need help?
General
