Keysight Technologies N6700 User Manual

Quick Reference 1
Keysight N6700 User’s Guide 21
SCPI Command
Description
TRIGger (continued)
:SOURce BUS | CURRent<1-4> | EXTernal | PIN<1-7>
|TRANsient<1-4> | VOLTage<1-4>, (@chanlist)
Sets the measurement trigger source
:TOUTput[:ENABle] <Bool>, (@chanlist)
Enables measurement triggers to be sent to a digital port pin
:VOLTage
[:LEVel] <NRf>, (@chanlist)
Sets the voltage trigger level
:SLOPe POSitive | NEGative, (@chanlist)
Sets the voltage trigger slope
:ELOG
[:IMMediate] (@chanlist)
Triggers the external data log immediately
:SOURce BUS|EXTernal|IMMediate|PIN<1-7>, (@chanlist)
Sets the external data log trigger source
:TRANsient
[:IMMediate] (@chanlist)
Triggers the output immediately
:SOURce BUS | EXTernal | IMMediate | PIN<1-7>
| TRANsient<1-4>, (@chanlist)
Sets the output trigger source
Common Commands
Command
Description
Command
Description
*CLS
Clear status
*RDT?
Return output channel descriptions
*ESE <NRf>
Standard event status enable
*RST
Reset
*ESR?
Return event status register
*SAV <NRf>
Saves an instrument state
*IDN?
Return instrument identification
*SRE <NRf>
Set service request enable register
*LRN
Returns a sequence of SCPI commands
*STB?
Return status byte
*OPC
Enable "operation complete" bit in ESR
*TRG
Trigger
*OPT?
Return option number
*TST?
Performs self-test, then returns result
*RCL <NRf> Recalls a saved instrument state *WAI Waits until all device commands are done

Keysight Technologies N6700 Specifications

General

Brand	Keysight Technologies
Model	N6700
Category	Power Supply
Language	English