Key Reference
System
152
System Info Accesses the submenu to check the system information as
below.
Key access: System > More
Show System Displays the number and description of the
options installed in your analyzer. It also displays the
instrument model number, product number, serial number,
the date of production, etc.
Installed Options displays the installed option list.
Error History Accesses a list of the 100 most recent errors
reported. The most recent error will appear at the bottom of
the list. If the same error occurs continuously, that error
message will not be added repeatedly to the list. Refer to
“Instrument Messages” on page 167 for details.
Service Accesses the submenu to set the service settings as below.
Key access: System > More > Service
Calibration Accesses the submenu to calibrate the time
base of the analyzer, load default values for the alignment
system.
Upgrade Enables the firmware upgrade process once the
USB disk with the firmware upgrade package plug
connected.
Prev Page/
Next Page
Access the previous/next page of error
messages.
Clear Error Queue Clears all the errors in the errors queue.
Time Base
by Ext
Calibrates the time base of the analyzer
with external source.
Amp
Alignment
Adjust the amplitude accuracy according
the internal cal out signal.
CAL OUT
On Off
Turns the internal amplitude reference
signal on or off. When this signal is on, the
RF input is disabled.
To Next Page
Loading...
