216 Keysight N9938-90003 User’s Guide
System Settings
Run/Hold
“File Saving Naming Options” on page 239
“System Configuration” on page 244
“Options (Licensing)” on page 244
“GNSS (GPS+) and GPS” on page 245
“Frequency Reference Source” on page 250
“Variable Voltage Source (Opt. 309)” on page 251
“Security Level” on page 252
“Date and Time, Format, and Time Zone Settings” on page 253
“LAN Settings” on page 254
“Power ON” on page 256
“FieldFox Package Installer” on page 257
“Date and Time, Format, and Time Zone Settings” on page 253
“Service Diagnostics” on page 259
“Understanding the Fan Controls” on page 261
See Also:
“Install the Lithium-Ion Battery” on page 20
“FieldFox High Temperature Protection” on page 22
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the
results of a specific measurement sweep.
The current sweep mode is shown on the screen as:
— Continuous
—Hold
— is displayed while a single sweep occurs.
How to perform a single sweep while in Hold
—Press Sweep 3.
— Then choose one of the following:
To Next Page
Loading...
Need help?
General
