Keysight B Series - Power on

256 Keysight N9938-90003 User’s Guide
System Settings
System Configuration
— Static - Set the IP Address manually. The Address remains until you
change it.
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
format nnn.nnn.nnn.nnn
— Static Gateway - Enter the Static Gateway – including periods - in the
format nnn.nnn.nnn.nnn
— Static DNS - Enter the Static DNS – including periods - in the format
nnn.nnn.nnn.nnn
— Apply Settings Choose from:
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
—Press Done Edit when finished.
Power ON
When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
How to set Power ON
—Press System 7
—Then System Configuration
—Then More
—Then Power ON
— Then choose from the following:
— Auto
The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using
Static IP addresses:
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.