222 Keysight N9938-90003 User’s Guide
System Settings
Utilities
Utilities
FieldFox utilities settings will not survive a shut down. When your FieldFox is
turned OFF, then back ON, these settings default to their factory settings.
How to view and change Utilities Settings
—Press System 7
—Then Utilities Opens the Utilities softkey menu.
Utilities Softkey Choices
Then choose one of the following:
— Mapping
– (Requires Option 352) opens a menu of softkeys that enables
the Indoor / Outdoor on–the–box mapping features. Refer to Chapter 15,
“Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer
Mode (Option 233 on N991xB), and GPS Receiver (Option 307)).”
— Phased Array Antenna
(PAA – Requires Option 360) - opens a menu of
softkeys that enables the PAA measurements. Refer to Chapter 13, “5G
Rapid Prototype Phased Array Antenna – Option 360.”
— USB Antennas
– opens a menu of softkeys that enables the triaxial antenna
feature, for use in EMF measurements. Refer to Chapter 14, “USB Antennas
– (Full Capability Requires EMF Option 358, and either SA mode (Option
233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted Option
378).”
— Freq Extnd
– opens a menu of softkeys that enables frequency extender
feature, for use with OML heads. Refer to
“How to view and change the
Frequency Extender (Freq Extnd) Settings” on page 223
.
For information on the Phase Array Antenna and USB antennas softkeys,
refer to Chapter 13, “5G Rapid Prototype Phased Array Antenna – Option
360.” and "USB Antennas" an Chapter 14.
IMPORTANT!
The Frequency Extender (Freq Extnd) is only active (available) when one of
the following modes are enabled: SA/RTSA/IQA/OTA/PAA/VSA (via the
Remote Server feature).
When OML millimeterwave extenders are used, Cable and Antenna
corrections, if On, are included in eCorr, or Extended Corrections.