Keysight N774 C Series

Keysight N774xC Series Multiport Power Meter Programming Guide 103
Error Codes 5
-283 "Illegal variable name"
-284 "Function currently running (StatModuleBusy)"
Description:
This error is generated when a function is currently running on a module so that it cannot process
another command.
Example:
When a powermeter is running a logging application, you are not able to configure the logging
application parameters (also see -200).
-285 "Program syntax error"
-286 "Program runtime error"
-290 "Memory use error"
-291 "Out of memory"
-292 "Referenced name does not exist"
-293 "Referenced name already exists"
-294 "Incompatible type"
-300 "Device-specific error"
-303 "Module slot empty or slot / channel invalid"
Description:
The user has send a command to an empty slot.
-310 “System error”
[Indicates that some error, termed “system error” by the device, has occurred. This code is
device-dependent.]
-311 "Memory error"
-312 "PUD memory lost"
-313 "Calibration memory lost"
-314 "Save/recall memory lost"
-315 "Configuration memory lost"
-320 "Storage fault"
-321 “Out of memory”
[An internal operation needed more memory than was available.]
Error
Number String