Keysight N774 C Series

94 Keysight N774xC Series Multiport Power Meter Programming Guide
4 Measurement Operations & Settings
Parameters: DISabled:
AVGover:
MEASure:
Never
When averaging time period finishes
When averaging time period begins
Response: None
Example: :trig1:outp dis
Affects: All power meters
Command: :TRIGger:CONFiguration?
Syntax: :TRIGger:CONFiguration?
Description: Returns the hardware trigger configuration.
Parameters: None
Parameters: 0 or DISabled:
1 or DEFault:
2 or PASSthrough:
3 or LOOPback:
Trigger connectors are disabled.
The Input Trigger Connector is activated, the incoming trigger response for each slot.
A trigger at the Input Trigger Connector generates a trigger at the Output Trigger
Connector automatically. No triggers from the instrument at the output.
The same as PASSthrough. This is included for compatibility reasons.
Example: :trig:conf? -> DEF
Affects All power meters
Command: :TRIGger:CONFiguration
Syntax: :TRIGger:CONFiguration
Description: Sets the hardware trigger configuration with regard to Output and Input Trigger Connectors.
Parameters: 0 or DISabled:
1 or DEFault:
2 or PASSthrough:
3 or LOOPback:
Trigger connectors are disabled.
The Input Trigger Connector is activated, the incoming trigger response for each
slot.
A trigger at the Input Trigger Connector generates a trigger at the Output Trigger
Connector automatically. No triggers from the instrument at the output.
The same as PASSthrough. This is included for compatibility reasons.
Response: none
Example: :trig:conf dis
Affects All power meters