Chapter 5 Motor Selection,Trial Operation and
Parameter List
5.1 Driver and motor configuration
There is no default motor type set in driver,so users need to set the motor model before using the
driver.Please refer to the selection table when setting the motor model.
1. Customers have the data file（No need to configure motor）
Use the CD-PC software to download data file to servo driver, then driver and motor can work
normally. Please contact us if there is any problem after downloading. In CD-PC, click the
Extend-->Write Driver Config. Then open the data file (For example, name.cdi), write it to driver.
To Next Page
Loading...
