Kinco CD2S Series - Panel Operation Procedures

To Next Page

To Previous Page

4.2 Operation on Digital Operation Panel

Power ON

Press MODE

Switching of basic menus

Parameter display (current speed is

displayed by default)

Press

Set driver instructions

Set real-time display of data

Set control loop parameters

Settings

I/O parameters

Mode operation parameters

Set motor parameters

Set driver parameters

Trial operation

Check wrong history records

Loop

Fig. 4-1 Operation on a digital operation panel

Note: If a non real-time display interface is displayed for the control panel, and no key operation occurs, the

real-time display interface is automatically skipped after 20 seconds to avoid misoperation.

Example 4-1: Set the denominator of electronic gear ratio to 10000 with

number system switching

1. Press MODE. The main menu is displayed. Choose F003.

Related product manuals