Kinco CD2S Series - Debugging Examples

Kinco CD2S Series

111 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

96

8.4 Debugging example

8.4.1 Oscilloscope

1. Enter oscilloscope

2. Parameters for Oscilloscope

Table of Contents

Default Chapter1
- Table of Contents1
- Contents1
Chapter 1 Product Acceptance & Model Description4
Chapter 2 Precautions and Installation Requirements9
Chapter 3 Interfaces and Wiring of CD2S Driver13
Chapter 4 Digital Operation Panel19
- Introduction19
- Operation on Digital Operation Panel21
  - Example 4-1: Set the Denominator of Electronic Gear Ratio to 10000 with Number System Switching21
  - Example 4-2: Set the Speed to 1000 RPM/-1000 RPM with Separate Regulation of Bits22
Chapter 5 Motor Selection,Trial Operation and Parameter List24
Chapter 6 Operation on Input/Output Ports46
- Digital Input Signals46
- Digital Output Signals53
Chapter 7 Mode Operation58
Chapter 8 Control Performance90
Chapter 9 Communication103
- Transport Protocol103
- Data Protocol104
  - Download(From Host to Slave)104
  - Upload(From Slave to Host)105
Chapter 10 Troubleshooting108
- Alarm Messages108
- Alarm Causes & Troubleshooting109
Chapter11 Appendix110
- Appendix 1: Selection Table for Brake Resistor110
- Appendix 2:Selection Table for Fuse111

Related product manuals

Preview: Kinco CD420

Preview: Kinco CD3 Series

Kinco CD3 Series

Kinco CD423-AA-000

Kinco FD425-LA-000

Preview: Kinco FV100-2S-0004G

Kinco FV100-2S-0004G