(1) Cap (2) Connector
2. Remove the cap.
3. Press and turn the socket coun-
terclockwise to remove the bulb. If
the bulb is blown, replace it with a
new bulb with the same capacity.
M55O799A
If using a bulb other than the
damaged and the tractor can
Make sure to use bulbs with
•
•
WARNING
Make sure to use a KIOTI genu-
ine bulb. Using a non-recom-
-
ily be fogged due to rain or
car wash. This is because of
-
tween the inside and outside
•
•
CAUTION
The work lamp uses a halogen bulb.
Do not touch the illuminating part of
the halogen bulb.
The bulb life can be shortened by
finger prints, dust and moisture, or
the bulb even can be broken. Clean
it with soft cloth.
Be careful of the following when re-
placing the halogen bulb:
Replace the bulb after it is cooled
down.
Do not touch the glass of the bulb.
Handle the bulb with care and be
careful not to scratch or rub it.
Do not let the bulb contact with liq-
uid when it is illuminated.
Wear protective glasses when re-
placing the bulb.
To Next Page
Loading...
