SANARIUM B, S
PAGE 14
50701206/02.18
7. Controller
7.7. Touchscreen - Section 3: Status bar
The status bar is for display only and has no touchscreen functions.
The symbol display depends on the configuration.
Symbol: Display/function:
WLAN is installed and activated.
The dot inside the symbol indicates that a WLAN module is installed.
The waves appear if there is a connection between the controller and a
router.
Green Sauna is activated. The function is switched on/off via a separate
touch key on the sauna.
When the Green Sauna function is switched on, any units that are not
required can be switched off. The cover flap of the ventilation system is
closed.
Lit: Subsequent drying is activated.
(Optional) Flashing: Low water level.
Voice control is activated.
Output from the sauna heater is requested via the key switch.
The key symbol is displayed for 30 minutes after changing a bathing
parameter. Changes to a bathing parameter can be confirmed by pressing
the key switch on the sauna cabin within 30 minutes.
. When the key functions are activated, the settings and the key-switch
symbol remain displayed (for max. 30 minutes) until the key switch is
pressed.
The remote power-on unit is connected. The sauna can be operated via
both the remote power-on unit and the control panel.
The TOUCHCONTROL is connected. The touchscreen on the controller is
locked.
The Climate Manager is connected and in operation.
The Climate Manager automatically controls the speed of the fan.
The Klafs IMES-1 is connected. There are no faults in the data exchange
between Klafs IMES-1 and the controller.
The controller is in Service mode.
To Next Page
Loading...
