SANARIUM B, S
PAGE 24
50701206/02.18
9. Operation
9.2. PUR bathing mode
The PUR bathing mode is only available with the Sauna bathing mode.
Starting PUR bathing mode
. To start the P
UR bathing mode, the Sauna
bathing mode must be started and the cabin
must reach the preset temperature.
Once the preset temperature has been reached,
the symbol (1) appears.
1. Press the symbol (1).
The backlit ring for P
UR is displayed.
. During P
UR operation, the sauna heater is
switched off.
. The heat stored in the sauna stones is
released.
. After approximately 20 minutes, or once the
temperature in the sauna cabin has
decreased by approximately 15 °C, the P
UR
bathing mode stops automatically. The sauna
heater begins heating again.
1
Stopping the PUR bathing mode
1. Press the symbol (1).
The backlit ring and the P
UR symbol go out.
The sauna heater begins heating again.
1
To Next Page
Loading...
