SANARIUM B, S
PAGE 6
50701206/02.18
3. Technical data
Controller type 18033: 3/N/PE ~400 V, max. 9 kW.
Optional InfraPLUS: 1/N/PE ~230 V, max. 350 W per InfraPLUS unit.
Ambient conditions: Temperature 0 °C to 35 °C, max. relative humidity 80 %.
4. Intended use
The controller is intended for use with the heaters tested and approved by the German VDE
(Association for Electrical, Electronic and Information Technologies) or TÜV (Technical Inspection
Authority):
d Sauna heater with or without evaporator
d InfraPLUS (optional).
The controller is only to be used as intended. Intended use also assumes adherence to the instructions
for operation, installation and servicing as prescribed by the manufacturer. The manufacturer is not
responsible for any damage resulting from unintended use or unapproved changes to the controller.
The user does these things at their own risk.
The controller may only be operated, maintained and repaired by persons who are familiar with it
and aware of the risks involved. Always observe the relevant German VDE regulations and other
generally recognised safety precautions.
5. Safety precautions for infrared emitter
Note the following information before using infrared emitters.
d Do not use the infrared cabin within 24 hours of being exposed to UV radiation from an
artificial source or sunbathing.
d Consult a doctor before using the infrared heat cabin if you are at risk of overheating or if you
suffer from cardiovascular diseases.
d Seek medical advice to avoid triggering erythema ab igne as a result of exposure to infrared
radiation. Do not expose yourself to the radiation again if the erythema becomes chronic (the
skin stays red for longer than one day) or if reticulated colour changes remain after regular
exposure to infrared radiation.
d Do not use the infrared cabin if you have reduced sensitivity to heat, have consumed alcohol or
have taken sedatives.
To Next Page
Loading...
