EasyManua.ls Logo

Klafs 18033 - Cleaning and Maintenance; Sauna Cabin and Touchscreen Cleaning

Klafs 18033
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SANARIUM B, S
PAGE 58
50701206/02.18
12. Cleaning and maintenance
12.1. Cleaning the sauna cabin
The high humidity in SANARIUM mode does not damage the wood of your cabin.
A prerequisite is that the cabin is well ventilated after use and the drying phase is completed.
Never use a hose or pressure washer on the inner cabin walls, benches or seats.
Dirty benches
Wipe the wooden surfaces with a damp cloth.
Sand any rough surfaces on the benches with fine sandpaper if necessary.
The benches can also be rinsed with a 3 % hydrogen peroxide solution (available from specialist
dealers).
Disinfectants are highly corrosive.
It is therefore important to observe to the relevant safety precautions.
Always wear rubber gloves when cleaning the cabin.
The outer cabin walls have been varnished or waterproofed.
Do not varnish, paint or waterproof the inner panelling or the inner cabin walls and
units (benches, etc.).
12.2. Cleaning the touchscreen
Switch the controller off at the main switch before
cleaning.
The touchscreen's surface should only be cleaned
using a soft cloth.
Moisten the soft cloth with water.
For more stubborn marks, soak the soft cloth in an
organic solvent such as light petroleum.
Do not use corrosive solvents such as
isopropyl alcohol (IPA).

Table of Contents

Other manuals for Klafs 18033