SANARIUM B, S
PAGE 53
50701206/02.18
11. If something does not work
11.2. Other possible errors
Fault Cause Remedy
The controller
cannot be
switched on.
No mains power available. Check the FI switch and the fuse in the
power supply.
Fuse SI102 or SI104 has
blown.
Replace fuse SI102 (1.6 AT) or
SI104 (1.0 AT), or inform Klafs service
engineers.
LED on the
humidity sensor
flashes, the cloud
symbol in the
controller display
flashes
(SANARIUM B).
There is no water. Fill the evaporator with water.
' See page 36/37.
There is no steam
escaping
(SANARIUM B).
Line break. ' See the SANARIUM B
Installation/Servicing Instructions
5080107/5080111.
The heating rod is faulty.
The cabin light
does not light up
after having been
switched on.
The bulb is defective. Change the bulb.
1. Disconnect the controller from the
mains.
2. Replace with a bulb of the same
wattage.
No mains power. Check the FI switch and the fuse in the
power supply.
Light fuse SI103 has blown. Replace light fuse SI103 (0.6 AT) or inform
Klafs service engineers.
The fan is not
working.
No power at
output AG1.
No mains power. Check the FI switch and the fuse in the
power supply.
Fuse SI104 has blown. Replace fuse SI104 (1.0 AT) or inform Klafs
service engineers.
The fan is defective. Replace the fan.
1. Disconnect the controller from the
mains.
2. Replace with a fan of the same
wattage.
The main switch is not
switched on.
Switch on the main switch.
No power at
output AG2.
Fuse AG2 SI101 has blown. Replace fuse AG2 SI101 (1.25 AT) or
inform Klafs service engineers.
The controller is in standby
mode.
Start a bathing mode.
Continued on the next page
To Next Page
Loading...
