Klafs 18033 - Bathing Time and Preset Start

SANARIUM B, S
PAGE 44
50701206/02.18
10. Custom settings
10.5. Setting the bathing time
In InfraPLUS mode the bathing time can be set to between five and 30 minutes to the
nearest minute.
Changing the bathing time
1. Press the symbol (1) or (2).
The digits for the hour (2) start flashing.
2. Set the desired bathing time (separately for hours
and minutes) by pressing the +/- symbols (3).
3. Apply the set bathing time by pressing the
OK symbol (4) in each case.
. The controller will automatically cancel input mode
and retain the existing setting if the altered setting
is not confirmed by pressing OK within five
seconds.
1
24
3
10.6. Setting preset time mode
Risk of fire!
Before commissioning the controller, always check that there are no inflammable
objects on or near the sauna heater.
Programming the pre-programmed
start time
1. Press the symbol (5).
The pre-programmed start time (6) starts flashing.
2. Set the desired pre-programmed start time
(hour and minutes) by pressing the
+/- symbols (7).
3. Apply the set pre-programmed start time (hour
and minutes) by pressing the OK symbol (8)
in each case.
. The controller will automatically cancel input
mode and retain the existing setting if the
altered setting is not confirmed by pressing
OK within five seconds.
. The controller goes into standby mode and
starts heating automatically before the set
time.
. The sauna cabin is ready to use at the
programmed time.
5
68
7