Klafs 18033 - InfraPLUS Mode Operation

SANARIUM B, S
PAGE 27
50701206/02.18
9. Operation
9.4. InfraPLUS mode (optional)
Risk of fire!
Before commissioning the controller, always ensure that there are no flammable objects
near the sauna heater or infrared heater in the cabin.
On models with a key switch (optional), changes to bathing parameters in the sauna
cabin must be confirmed by pressing the key switch within 30 minutes.
The key switch symbol in the display goes out after confirmation.
Starting InfraPLUS
1. Press the symbol (1).
The bathing parameters flash for approx. three
seconds. After that, the last program used for the
selected bathing mode is automatically started.
The backlit ring for InfraPLUS is displayed.
The sauna heater and the InfraPLUS infrared heater
switch on. The cabin heats up.
. The infrared heater will not switch on if the
cabin temperature is over 50 °C, e.g. due to
a previous sauna on SANARIUM session.
Once the cabin has reached the preset
temperature, the symbol (2) appears. The cabin is
ready to use.
' If you would like to start a stored program for
the selected bathing mode, see page 40.
' To change the InfraPLUS intensity, see
page 43.
' To change the bathing time, see page 44.
1
2
Continued on the next page