SANARIUM B, S
PAGE 28
50701206/02.18
9. Operation
9.4. InfraPLUS mode (optional)
Continued
Starting InfraPLUS
2. Step inside the cabin and put the backrest
into position:
Raise the backrest, swing it out and then set it
down on the bench.
3. Place a towel down where you will sit.
4. Sit down in front of the infrared heater with a
naked upper body.
. The infrared heater is controlled by measuring
the skin's temperature (SensoCare).
SensoCare:
d Fully automatic heat intensity
control
d Sensors integrated into the
infrared heater
d Protects the skin against high
temperatures
d SensoCare measures the skin
temperature at four locations
without touching the skin, and
automatically starts the infrared
heater (if the upper body is
unclothed)
d Gentle heating occurs on
several levels.
Restarting InfraPLUS mode
. Stand up from the infrared seat and wait at
least ten minutes before sitting down again.
After you have sat down again, wait until the
infrared heaters switch on again and the
remaining program time is displayed.
Continued on the next page
To Next Page
Loading...
