Klafs 18033 - Page 29

SANARIUM B, S
PAGE 29
50701206/02.18
9. Operation
9.4. InfraPLUS mode (optional)
Continued
Stopping InfraPLUS
1. Press the symbol (1).
The bathing mode is cancelled. The backlit ring
goes out.
Automatic follow-on program after
using InfraPLUS mode
1. On models with wall-mounted air extractor
control: Set air extractor opening to
position 4.
. If InfraPLUS was used for more than ten
minutes, the follow-on program will start
automatically after ending the program.
Symbol (2) is displayed. The remaining
program time before the follow-on program
starts is displayed digitally (3).
. The sauna heater heats up again, causing an
increased exchange of air. This ventilates the
cabin.
. The controller automatically goes into standby
mode after the follow-on program has
finished. The time appears on the display.
2
3
1
Airing the cabin
. After using the Sauna/SANARIUM/InfraPLUS
mode or follow-on program, air the cabin by
opening the cabin door.
. Open the vent flap (optional) fully when airing
the cabin (4).
4