Klafs 18033 - SANARIUM Mode Operation

SANARIUM B, S
PAGE 25
50701206/02.18
9. Operation
9.3. SANARIUM mode
Risk of fire!
Before commissioning the controller, always ensure that there are no flammable objects
near the sauna heater or infrared heater in the cabin.
On models with a key switch (optional), changes to bathing parameters in the sauna
cabin must be confirmed by pressing the key switch within 30 minutes.
The key switch symbol in the display goes out after confirmation.
Starting SANARIUM
. For SANARIUM bathing mode, commission
the evaporator beforehand.
' Preparing the evaporator - see pages 36,
37.
1. Press the symbol (1).
The bathing parameters flash for approx. three
seconds. After that, the last program used for the
selected bathing mode is automatically started.
The backlit ring for SANARIUM is displayed.
The sauna heater switches on and the cabin heats
up.
Once the cabin has reached the preset
temperature, the symbol (2) appears. The cabin is
ready to use.
' If you would like to start a stored program for
the selected bathing mode, see page 40.
' To change the temperature, see page 42.
' To change the humidity, see page 42.
' To change the bathing time, see page 44.
1
2
Continued on the next page