Klafs 18033 - Page 26

SANARIUM B, S
PAGE 26
50701206/02.18
9. Operation
9.3. SANARIUM mode
Continued
Stopping SANARIUM
1. Press the symbol (1).
The bathing mode is cancelled. The backlit ring
goes out.
Automatic follow-on program after
SANARIUM mode
1. On models with wall-mounted air extractor
control: Set air extractor opening to
position 4.
. If SANARIUM was used for more than ten
minutes, the follow-on program will start
automatically after ending the program.
Symbol (2) is displayed. The remaining
program time before the follow-on program
starts is displayed digitally (3).
. The sauna heater heats up again, causing an
increased exchange of air. This ventilates the
cabin.
. The controller automatically goes into standby
mode after the follow-on program has
finished. The time appears on the display.
2
3
1
Airing the cabin
. After using the Sauna/SANARIUM mode or
follow-on program, air the cabin by opening
the cabin door.
. Open the vent flap (optional) fully when airing
the cabin (4).
4