SANARIUM B, S
PAGE 32
50701206/02.18
9. Operation
9.6. Interior display (optional), with SaunaPUR button,
with/without IR receiver
Continued
Starting the SaunaPUR bathing mode
. Prerequisite: The temperature must be reached. The
symbol must appear in the display.
' If necessary, start the Sauna bathing mode, see page 23.
. It is possible to start the SaunaP
UR bathing mode using the controller or on the interior display
(optional).
1. Press the SaunaP
UR bathing mode button.
. If
appears in the seven-segment display, wait until the temperature for the SaunaPUR bathing
mode has been reached. Then try again.
. When the SaunaP
UR bathing mode is active, the SaunaPUR bathing mode LED lights up.
. After approximately 20 minutes, or once the temperature in the sauna cabin has decreased by
approximately 15 °C, the SaunaP
UR bathing mode stops automatically. The sauna heater begins
heating again.
Stopping the SaunaP
UR bathing mode
1. Press the SaunaP
UR bathing mode button.
. The SaunaP
UR bathing mode LED goes out. The sauna heater begins heating again.
To Next Page
Loading...
