SANARIUM B, S
PAGE 23
50701206/02.18
9. Operation
9.1. Sauna mode
Risk of fire!
Before commissioning the controller, always ensure that there are no flammable objects
near the sauna heater or infrared heater in the cabin.
To enjoy a sauna, empty the evaporator water tank.
' To decommission the evaporator, see page 38, 39.
On models with a key switch (optional), changes to bathing parameters in the sauna
cabin must be confirmed by pressing the key switch within 30 minutes.
The key switch symbol in the display goes out after confirmation.
Starting Sauna mode
1. Press the symbol (1).
The bathing parameters flash for approx. three
seconds. After that, the last program used for the
selected bathing mode is automatically started.
The backlit ring for SAUNA is displayed.
The sauna heater switches on and the cabin heats
up.
Once the cabin has reached the preset
temperature, the symbol (2) appears. The cabin is
ready to use.
' If you would like to start a stored program for
the selected bathing mode, see page 40.
' To change the temperature, see page 42.
' To change the bathing time, see page 44.
1
2
1
Stopping Sauna mode
1. Press the symbol (1).
The bathing mode is cancelled.
The backlit ring goes out.
The controller then goes into standby mode.
To Next Page
Loading...
