Upwards landing call for
landing xx
Makes an upwards landing call, depending
on the call release.
25* = upwards landing
call for landing 5
Downwards landing call for
landing xx
Makes a downwards landing call,
depending on the call release.
35* = downwards
landing call for landing
5
Checks all relay outputs as well as travel
signal outputs to the frequency inverter.
Displays any folders and files available on
the SD card.
Checks the GENIUS20 bus displays.
Checks the IO32 card on the processor
board for functioning.
Saves parameter and settings to the
internal flash memory.
Data transmission to
displays
All set display characters per landing are
transmitted to the displays connected to
the GENIUS20 bus.
Restart of the control computer is
enforced.
Displays all complete backups (folders) on
the SD card.
Backs up the current lift software on the SD
card if no current backup is available.
Displays the current software version.
Restores the software saved on the SD
card in the root - for this purpose, the file
name index (3-digit number) must be
entered.
Restore software with
suffix 001 using
698001*
Delete UCM error / UCM
test
Deletes the current UCM error.
The UCM test mode can
only be enabled if the
car is in the zone and no
UCM error is present.
Travel to upper final limit
switch
Car travels to upper final limit switch (also
required for Certification).
Travel to lower final limit
switch
Car travels to lower final limit switch (also
required for Certification).
Triggers a UCM valve test for hydraulic
systems which, in case of successful test,
must shut down for UCM fault.
Enter page number (three digits) to go to
the associated parameter page.
Deletes the current error.
Set I/O at the landing bus
module
Landing bus:
xx is the address of the bus module
(between 00 and 63)
y is the I/O number
To Next Page
Loading...
Need help?
General