Kleemann GENIUS20 User Manual

131
MA06-03-1-01
Menu
Parameter
[Direct access]
Description
Default
value
Value
Range
❑ In the shut-down landing, the door is opened
and closed when the idle time has elapsed.
❑ The lift car light is switched off if the
corresponding parameter "Switch car light" in
the "Relay addresses" parameter set is
programmed.
❑ When the key is removed, the lift immediately
changes to the original operating mode or
possibly to an operating mode activated in the
meantime.
I: SO input control
cab.
Definition of an input for the switch-off function in
the control cabinet. The function is analogous to the
above-mentioned function " I:SO key floor".
*SO key floor
signal:
Selection whether the inputs for the switch-off
signal are applied by normally close contacts or
normally open contacts.
N.O./N.C.
Door open in
landing
Selection whether the doors are to remain open or
closed after the switch-off function is enabled.
NO
YES/NO
Group
[CMD -> 7073 ->
OK]
Query whether several cars are to run as a lift group.
By choosing “YES” the group parameters are made
visible.
YES/NO
I:Start SO with
pulse
Definition of an input for switching-off the
installation (controller/light off) via a temporary
impulse (>10 msec.) e.g. by enabling a push-button.
Usually, this is carried out with a key switch in
landing or control cabinet.
I:End SO with
pulse
Definition of an input for switching back on; likewise
performed via an impulse.
Floor: Call
Definition of the first landing to be approached after
initializing the switch-off function, in order to urge
people to leace the car. It is usually the landing in
which the switch-off key is located.
2
1-max.
landing
Floor: Switch off
Definition of a landing where the car is parked after
initializing the switch-off function.
2
1-max.
landing
O:SO active
Definition of an output for optic signaling of the
active switch-off function.

Kleemann GENIUS20 Specifications

General

Brand	Kleemann
Model	GENIUS20
Category	Controller
Language	English