The AWT Transport is an automatic goods transport system which integrates the lift. A distinction is
made between goods transportat according to the PSB or SWISSLOG standard. The selection is made
via page 216. If SWISSLOG PLC is set “YES”, the system switches from PSB to the SWISSLOG method
and page 215 is adapted accordingly.
If the respective key operated switches are installed in the landings and in the car, you can also switch
over to manual operation in the PSB mode.
[Direct access: CMD -> 7215 -> 7216]
Parameter
[Direct access]
Definition of an input for reporting the “ready”
signal of the freight transportation system’s
controller.
Definition of an input for the signal “Automatic
mode” of the freight transportation system’s
controller. This signal will remain until the next
manual mode.
Definition of an output which turns active after
the key for manual operation in the car has been
pulled, thereby indicating to the controller of
the freight transportation system a request for
automatic mode.
Definition of an input for the “Manual release”
signal of the freight transportation system’s
controller. This signal is preconditioned on a
previous manual mode by the lift controller.
Definition of an output for the manual mode of
the freight transportation system’s controller.
Manual mode is activated by a key switch in the
corresponding landing. When the manual mode
signal of the transportation system applies, the
To Next Page
Loading...
Need help?
General