Kleemann GENIUS20 - Page 148

148
MA06-03-1-01
Menu
[Di rect access: CMD -> 7115 -> 7116]
Parameter
[Direct access]
Description
Default
value
Value
Range
I:Sabbath Mode
Address input for activating the Sabbath-
function.
T:Sabbath Begin (hhmm)
Sabbath-function starting time in hours
and minutes. If the starting time is set to 0,
the activation input serves as Sabbath-
function starting point.
0
T:Sabbath End (hhmm)
Sabbath-function ending time in hours and
minutes. If this value is set to 0, the release
of the activation input marks the Sabbath-
function ending point.
0
1.O:Sabbath active
Address output for the illuminated display
of each landing, which are connected to
the bus modules.
O:Sabbath main landing
Address output for the illuminated display
in the main landing panel.
O:Sabbath in cabin
Address output for the illuminated display
in the car operation panel.
O:Car call disable
Definition of an output for deactivating the
car calls.
O:Landing call disable
Definition of an output for deactivating the
landing calls when Sabbath mode or
Sabbath Stanby mode is activated.
Ι: Standby Sabbath mode
Address input for activating the Sabbath-
Standby mode.
T:Stop between floors (s)
Dwell time in the landings (except main
landing) during which the landing doors
remain open – measure in seconds.
Afterwards, door closing time follows.
15