Entry of the absolute encoder zero, if known. This value
is read and set by the absolute encoder during TeachIn.
In case there is deviation between landing door and car
door sills, ABS reference point can be manually changed.
It indicates the height of landing 1 at the absolute
encoder.
Note: In the controller, the height of landing 1 = 0.
If the ABS zero is changed within the limits of landing
distances (and not more), the distances between the
subsequent floors are not affected by these alterations.
It is thus possible to correct a zero value already set. In
case the distance indeed changes by a value larger than
the pre-set landing distance, the entire area is shifted as
a consequence.
Entry or reading of the height of landing 2. It is calculated
by entering the distance between landings 1 and 2
according to the following: height of landing 2 = 0 +
distance landings 1-2.
Note: Changing this value results in changes of the
associated landing distance as well as alterations to the
subsequent distances, since the zero value remains the
reference point!
Entry or reading of the height of landing 3. It is calculated
by entering the distance between landings 2 and 3.
Height of landing 3 = height of landing 2 + distance
landings 2-3 etc.
The following pages contain further landing heights, if
required.
To Next Page
Loading...
Need help?
General