[Direct access: CMD -> 7109]
Parameter
[Direct access]
Time in seconds after which the car light is
switched off. The initial point is the last
completed door movement. Setting the
value to 0 does not effect an automatic
deactivation.
Time in seconds after which the display on
the bus are switched off. The initial point is
the last completed door movement.
Setting the value to 0 does not
automatically shut-down the displays
(deactivation).
In order to save electricity the hand-
terminal display dims after the pre-set time
interval (in seconds) elapses.
Here, setting the value to 0 deactivates the
shutting-down process (dimming) of the
display.
Light off with open
door?
Defines whether the car lights are switched
off when the lift parks with open doors. A
power loss will result to the re- activation
of the car lights.