Kleemann GENIUS20 User Manual

79
MA06-03-1-01
Menu
Parameter
[Direct access]
Description
Default
value
Value
Range
1.IO:Car selection car
call
This parameter is only active for installed groups:
Definition of the first input for car calls. That means
activation at the configured address corresponds with
a car call. Within the group, this has the same effect
for the lift as a car selection.
1.O:landing call
released
Definition of the first output which is intended for
feedback concerning released landing calls. Here it
would be possible to connect an indicator field which
serves to report the current condition.
IO2:Landing call in CC
Definition of two subsequent IOs at the controller
intended for landing call up/down. Given the control
cabinet’s position in one landing, it is thus possible to
use the corresponding BUS-module and transfer the
call directly to the controller.
1.O:Direction up/down
Definition of the first output for the
upwards/downwards direction display. This output
may serve to connect e.g. a light board for status
display.
1.O: On g.direct.
up/down
Definition of the first output for upwards/downwards
travel continuation direction. This output may serve
to connect e.g. a light board for status display.
1.O: Out of order
Definition of the first output for the out-of-order
signal. This output may serve to connect e.g. a light
board for status display.
1.O: Car running
Definition of the first output for displaying that the car
is operating. This output may serve to connect e.g. a
light board for status display.
1.O: Car busy
Definition of the first output for displaying that the car
is busy. This output may serve to connect e.g. a light
board for status display.
1.O: Car here
Definition of the first output for displaying that the car
is in the required landing. That is, the lift is positioned
within the zone and the zone signal SM is available.
When door complet
open
This parameter configures the previous parameter
“1.O:Car here”: If “Yes” is selected, the output signal
for the display is only activated under the condition
that the door(s) are open additionally.
NO
YES/NO
O: Landing call pressed
Definition of an output indicating an active landing
call. One can indirectly activate a staircase light using
an extra relay: When a landing call is pressed in any
landing, a pulse with approx. 1s duration is activated.
This pulse is repeated every 30s until the travel
terminates. Further information: This function is
applicable in any operating mode.
1.O:Gong up/down
Definition of the first output for gong when travelling
upwards/downwards.

Kleemann GENIUS20 Specifications

General

Brand	Kleemann
Model	GENIUS20
Category	Controller
Language	English