Parameter
[Direct access]
Definition of an input to check, whether brake
shoe 1 – which is controlled by the inverter -
opens and closes properly when travelling.
Definition of an input to check, whether brake
shoe 2 – which is controlled by the inverter -
opens and closes properly when travelling.
Definition of an input to check, whether brake
shoe 3 – which is controlled by the inverter -
opens and closes properly when travelling.
Definition of the delay time for the check
brake.
Definition of an input to check the sink
prevention.
Determine an input to consider a temperature
switch in order that no unnecessary warm-up
travel is carried out in warm temperatures.
Definition of an input to activate the
installation travel.
Definition of an input for controlling an
upwards installation travel.
Definition of an input for controlling a
downwards installation travel.
Definition of an input which activates the
emergency call.
Definition of an input requesting to speak
during an emergency call.
Definition of an input for deleting the active
errors e.g. via monitoring center.
Definition of an input/output to block
simultaneous start up in case of multiple
installations. For this purpose, this I/O must
be programmed at each installation and
connected to the corresponding I/Os of the
other installations
Definition of an input to signal the regulator’s
operational readiness.
Definition of an input to monitor the
minimum pressure sensor.
To Next Page
Loading...
Need help?
General