All sensors are default selected when delivered except the air temperature one as non
compatible with Klereo Kompact.
5.15 Priorities and securities set-up
Go to menu « Priorities/Secur » to set up priorities and securities. They are all default
enabled when delivered.
Klereo
Heating priority
Pump priority: Disable or enable the filter pump security. When this option is marked, filtering
is stopped in case of low water flow rate. Default selected when delivered.
pH priority: this option gives priority to the pH regulation in “comfort mode”, i.e. filtering will
carry on after the regulated time in case the pH target value has not been reached. Default
selected when delivered.
Disinf. priority: this option gives priority to the disinfectant regulation in “comfort mode”, i.e.
filtering will carry on after the regulated time in case the disinfectant target value has not
been reached. Default selected when delivered.
This two treatment priorities are inactive when Klereo is in “Eco mode”.
Boost treat. priority: this option starts immediately the disinfectant boost treatment during 24h
and therefore forces filtering. After 24h, both filtering and disinfectant treatment come back to
their predefined operational modes. Default selected when delivered.
Heating priority: this option forces filtering at the end of its cycle providing that the water
temperature target value has not been reached. Heating carries on until the water
temperature reaches its target value then it stops together with filtering. Default selected
when delivered.
When the option is active, it is marked. To disable the option, press the screen selection key
below « disable » or press the “OK” key. Proceed the same way to enable the option. To
come out press the “C” key.
5.16 Inputs set-up
Klereo
To Next Page
Loading...