SECTION 1
INTRODUCTION
Jan 2001
Page 1-12
05114566
Never do any work on the unit without making sure the
electrical panel disconnect is locked out with a padlock in
the OFF position.
Never work on any high pressure component, or loosen any
high pressure fittings without first bleeding the system and
assuring there is no high pressure water present.
Make sure the safety devices are operational. To panic stop
the pump and bleed the high pressure, the EMERGENCY
STOP buttons must be pushed in. The system pressure
dump valves must be open.
Do not attempt to touch or be exposed to high pressure
water. The high pressure water will penetrate all parts of
human body without exception.
The liquid stream or material ejected by these extreme
pressures can injure or kill.
ARNING
ARNING
ARNING
ARNING
ARNING
To Next Page
Loading...
Need help?
General
