KMT STREAMLINE SL-IV 100 User Manual

SECTION 2
INSTALLATION
Jan 2001
Page 2-5
05114574
2.2.2 Service Connections
Cooling Water IN/OUT: Supply piping must be properly sized to handle the
necessary flow, and pressure. Piping must meet
national and local piping codes.
Cutting Water IN: Supply piping must be properly sized to handle the
necessary flow and pressure. Piping must meet
national and local piping codes.
HP Water OUT: Properly rated, sized, and well supported high
pressure (HP) piping must be connected to the
pump.
Drain: Cutting water released in the pump is discharged
from the drain port and must be piped to an
appropriate location (i.e. sewer line). Piping must
meet national and local piping codes.

KMT STREAMLINE SL-IV 100 Specifications

General

Brand	KMT
Model	STREAMLINE SL-IV 100
Category	Industrial Equipment
Language	English