SECTION 1
INTRODUCTION
Jan 2001
Page 1-1
05114566
1 SL-IV 100hp Waterjet Pump General Information
The Streamline SL-IV 100hp Waterjet Pump, maintains the level of component
reliability and ease of installation and maintenance that have made the KMT
Waterjet Streamline waterjet pumps the standard of the industry for both water
and Hydrobrasive™ applications.
The SL-IV 100hp Waterjet Pump uses low pressure water, which meets certain
quality requirements, and increases the pressure up to 3,800 bar (55,000 psi)
for ultra-high–pressure waterjet cutting, hydrobrasive cutting, cleaning, surface
preparation, etc.
This manual provides information for installation, operation, and maintenance
of the SL-IV100hp Waterjet Pump.
1.1 Physical Description
The 100hp waterjet pump is equipped with two simultaneously operating
hydraulic intensifiers, two high pressure attenuators, a motor/hydraulic pump
assembly, an electric starter panel, control sensors, solenoids and logic, control
interface panel, a low pressure water boost pump, and a low pressure water
filter.
It is enclosed in a frame with the dimensions of 77.75” length, 36.0” width, and
56.19” height. The high pressure system is conveniently mounted on a drip
pan. All service components are easily accessible from at least two sides
simplifying maintenance. The entire high pressure system can be removed from
the rest of the unit quickly for maintenance and serviceability.
To Next Page
Loading...
Need help?
General
