SECTION 3
OPERATION
Nov 2002
Page 3-5
05114582
STOP PROCEDURE
From the following conditions, follow the procedure below to stop the unit:
F5 LED ON
RUN light ON
CONTROL POWER ON
Unit Running
1. Push F5, RUN light will go OFF
F1 LED will go ON
CONTROL POWER ON light will stay ON
Unit will stop
2. Display Messages:
3.2.3 Remote Operation
The waterjet pump can also be started and stopped from a remote location. The
following can be wired remotely:
• RUN (status light)
• “Malfunction” pump (status light)
• Start
• Stop
• HI/LO dual pressure control
Note: If the proportional pressure control is installed in place of the HI/LO
hydraulic circuit proportional pressure control is available at the remote control
location.
• Emergency stop
3.3 Initial Start-Up Procedure
Make all connections for both electrical and water supply. Check the system
for all correct connections before the unit is started for the first time. Assure
safety standards have been observed. Following good safety practices will help
you avoid injury and damage to the pump.
Become familiar with this operation section, and
understand the electrical lights and switch functions before
attempting to operate this unit.
CAUTION
!
SLIV100-1 (ENG)
10.0 HRS
To Next Page
Loading...
Need help?
General
