SECTION 3
OPERATION
Nov 2002
Page 3-3
05114582
• Panel Electrical Disconnect Handle (13): Controls power to pump.
• RESET (F6): Must be pushed to re-open water supply valve after 2 minutes
of non-use. Also, must be pushed before motor will re-start following a fault
shutdown. The fault must be cleared before the reset will occur.
• RECIRCULATION MODE (F2): Starts the pump, but does not generate high
pressure water. This mode allows quicker cooling of the hydraulic oil in the
event of an over temperature shutdown. The pump will automatically turn
off after ten minutes of recirculation mode.
• LANGUAGE SELECTION (F8): Selects the display language (English,
Spanish, German, French, Italian, and Swedish).
To Next Page
Loading...
Need help?
General
