EasyManua.ls Logo

Kobold ZLS-2 - User Manual

Kobold ZLS-2
117 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
User manual for
DATA RECORDER
Firmware: v.3.36 b3 or higher
Logy Soft: v.1.10.0 or higher
S-Toolkit: v.2.1.0 or higher
Read the user's manual carefully before starting to use the unit or software.
Producer reserves the right to implement changes without prior notice.
Logy Soft
S-Toolkit
Model: ZLS-2

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Kobold ZLS-2 and is the answer not in the manual?

Summary

I. USER MANUAL FOR DATA RECORDER

1. BASIC REQUIREMENTS AND USER SAFETY

Guidelines for safe installation and operation of the unit, emphasizing user responsibility.

3. TECHNICAL DATA

Essential specifications including power, inputs, outputs, and communication interfaces.

4. DEVICE INSTALLATION

Instructions for unpacking, assembly, and connecting the data recorder.

4.3. CONNECTION METHOD

General caution about installation and connection procedures by qualified personnel.

6. PRINCIPLE OF OPERATION

Explains how the data recorder functions, including measurement and recording.

6.1. MEASUREMENT MODE

Explains how the unit measures and displays signal values from connected inputs.

6.2. MODES OF RESULT PRESENTATION

Outlines the different modes for displaying recorded measurement results.

6.3. PRINCIPLE OF OUTPUTS OPERATION

Explains how the data recorder's relay outputs operate and are controlled.

6.3.2. Outputs control

Details how relay outputs are controlled by channel alarms using logic functions.

7. DEVICE PROGRAMMING

Covers the process of configuring the data recorder's parameters and settings.

7.1. PARAMETERS EDITION

Details how to edit device parameters using the unit's interface.

7.4. MAIN MENU DESCRIPTION

Describes the main menu options for unit configuration and information.

7.4.3. Logging setup menu

Configures recording behavior (until full/cyclic) and triggering methods.

7.4.4. Input settings menu (common parameters)

Configures channel name, filtration, and alarm settings (AL1/AL2 modes, thresholds).

7.4.7. Outputs settings menu

Configures output mode, logic function, alarm sources, and delays.

7.4.9. RS485 port settings menu

Configures RS-485 interface address, baud rate, and response delay.

8. DOWNLOADING DATA FROM DATA LOGGER

Procedures for retrieving recorded data from the logger.

8.3. USB FLASH DRIVE (PENDRIVE) DATA DOWNLOAD

Instructions for downloading data using a USB Flash Drive.

II. USER MANUAL FOR “LOGY SOFT”

3. USING THE PROGRAM

Introduces the main interface and navigation of the Logy Soft program.

3.3. CONFIGURATION” MENU

Explains the Configuration menu for managing devices, groups, and program settings.

3.3.1. Devices ” tab

Details the "Devices" tab for managing installed devices and their properties.

III. USER MANUAL FOR “ S-TOOLKIT”

2. INSTALLATION AND STARTUP

Guides through the installation and initial startup of the S-Toolkit application.

3. USING PROGRAM

Introduces the main window and core functionalities of the S-Toolkit program.

3.1. “INPUTS SETTINGS” TAB

Allows configuration of channels, including single, selected, or all channels.

3.2. “OUTPUTS SETTINGS” TAB

Allows configuration of device outputs, including mode and logic functions.

3.7. UPDATING DEVICE FIRMWARE

Explains how to update the device firmware and USB driver using the software.

Kobold ZLS-2 Specifications

General IconGeneral
BrandKobold
ModelZLS-2
CategoryData Loggers
LanguageEnglish