User manual - DATA RECORDER and cooperating software
3.7. UPDATING DEVICE FIRMWARE
The
Firmware update
section in the
Device information
tab enables device software update.
To update the software: press the [
Update
] button. During update process the application
attempts to reset the unit. If the device will not reset within a few seconds, the device must be
reset manually by disconnecting and reconnecting power supply. Default baud rate during
device software update is 115200 bps. If transmission with this baud rate is not possible, check
the Slow
down baud rate to 38400 bit/sec..
Firmware update is possible (the [
Update
] button is active) if the updating software
version is newer than the device software. In exceptional cases (update interrupted
or unit does not operate after update) contact the manufacturer.
The newest version of device firmware is available at producer homepage.
The
USB driver update
section in the
Device information
tab enables USB interface driver
update. To update the software: press the [
Update
] button. During update process the
application attempts to write update file to the FlashDisk. After finish of the file writing put this
FlashDisk (containing update file) to USB input and wait for automatic updating process finish.
Firmware update is possible (the
USB driver update
section is visible) if device is
equipped with USB interface and update file version is newer than the USB driver
version of the device.
117
To Previous Page
Loading...