User manual - DATA RECORDER and cooperating software
Typical methods of grouping measurement channels:
• measurement channels recording the measurements of the same physical value
(e.g. temperature or humidity),
• measurement channels recording the measurements from sensors located in the same
places, e.g. “Assembly room”.
One measurement channel can belong to different groups.
Creating a new group
In order to create a new group:
• click on the [
New group
] button,
• assign a name to the new group.
Removing a group
In order to remove a group:
• check the desired group on the
Groups
list,
• click on the
[Remove group]
button.
Changing group name
In order to change a group’s name:
• check the desired group on the
Groups
list,
• click on the group again,
• the group name will be highlighted - the name can be edited. The edit can be cancelled
(restore previous name) by pressing the [
ESC
] key.
Upon completing the edit, confirm changes with
[
ENTER
] key.
Adding measurement channels to a group
In order to add a measurement channel to a group:
• check the group, to which the channel is to be added (the checked group is marked with a
green circle),
• then check one, or (holding down the
[Ctrl]
key) many channels of
Measurement
channels
list,
• finish the procedure using the [>>] button.
A maximum of 12 channels can be added to one group.
Removing a measurement channel from a group
To remove a channel from a
Group
:
• find the desired group on the
Groups
list,
• show the list of devices in the group using “
+
” mark,
• check the measurement channel to be removed,
• finish the procedure using the
[<<]
button.
To Next Page
Loading...