S008769 Rev A 5
Getting Started
Top View
C
AUTION
Make sure to maintain an additional 4-5” (10-13 cm) of additional clearance at the front, back,
and both sides of the scanner for proper ventilation.
Place the scanner at the front edge of a sturdy, level surface. If the scanner’s straight pass-
through feature is to be used, make sure to leave enough clearance at the back of the scanner
(see Side View-2 on page 4
).
1.4 External Component Identification
The external components that make up the scanner are identified in this section, along with a
detailed description of each.
To Next Page
Loading...
