72 S008769 Rev A
Ngenuity Operator Manual
2. Open the scanner’s transport cover (see 1.4.1 Scanner Front, “Transport Cover” on page 7
and “
Transport Cover Release Levers” on page 7)
3. Remove the bottom (back page) glass flat (see “Cleaning Glass Flats” on page 69)
4. Clean the new, bottom (back page) glass flat (see “
Cleaning Glass Flats” on page 69)
5. Insert the new, bottom (back page) glass flat (see “
Cleaning Glass Flats” on page 69)
5.3.3.2 Cameras’ Glass Covers
The cameras in Ngenuity scanners contain a glass cover (not to be confused with the glass flat)
that protect the camera from dust and paper particles getting inside of it. They are located directly
beneath the glass flats, between and below the LED lamps.
The cameras’ glass covers are part of the Optics group (see ”5.3.2
Optics” on page 68).
C
AUTION
The cameras’ glass covers should never be replaced. Do NOT attempt to remove a camera’s
glass cover. They should be cleaned only.
Back camera’s glass cover
LEDs
Glass flat removed
Bottom or back page
tray
Bottom or Back Page
Tray (as viewed from
top, left)
Front of scanner
To Next Page
Loading...
