82 S008769 Rev A
Ngenuity Operator Manual
5.3.5 Cleaning the Transport
Over time, the transport assembly components will become dirty and may feed documents
erratically or skew the documents as they enter the scanner. To prevent erratic feeding, clean the
transport every 50,000 pages fed or as needed. Different document types, the condition of the
documents being scanned, and the volume of scanning may require more frequent cleanings.
Item(s) Needed
• Transport Cleaning Sheets
N
OTE
BBH recommends cleaning the glass flats after cleaning the transport in the event the
transport cleaning sheets have left any residue on the glass flats which could cause image
issues.
To clean the transport, perform the following:
1. Establish communication between the scanner and the NOU (see ”2.2
Ngenuity Operator
Utility” on page 29)
2. Within the NOU, make sure one of the Custom Functions is set to “Feed Test Batch” (see
”2.2.3.3
Custom Functions” on page 38)
3. Press the F1 or F2 key on the scanner’s control panel (see ”2.1 Control Panel” on page 17),
depending on which key the Custom Function of “Feed Test Batch” was set to in the NOU
(see ”2.2.3.3
Custom Functions” on page 38), to start the scanner’s transport
4. Feed one, new transport cleaning sheet into the scanner’s transport (landscape)
5. After it exits the transport, run it through the scanner again
6. Flip the transport cleaning sheet over and run it through two times (repeat steps 4 and 5)
7. Press and hold the PAUSE/STOP button on the scanner’s control panel until the
transport stops running (about 2-3 seconds)
8. Press the CLEAR/RESTART button on the scanner’s control panel
9. Discard the used transport cleaning sheet.
N
OTE
After cleaning the transport, BBH recommends cleaning both glass flats, as residue from the
transport cleaning sheets can sometimes come loose and remain on the glass (see
”5.3.2.1
Glass Flats” on page 68).
To Next Page
Loading...
