S008769 Rev A 83
Maintenance
5.3.6 Lamps (LEDs)
CAUTION
The LEDs on Ngenuity scanners should NOT be cleaned or wiped with any type of wipes and/
or solvent
NOTE
The LED illumination system on Ngenuity scanners should last the life of the scanner with
normal use. If something happens that requires the replacement of the LEDs, contact the BBH
Help Desk at 1-800-SCAN-495 or your local BBH Authorized Service Provider (ASP). A list of
BBH ASPs can be found on the BBH web site at www.bbhscanners.com
.
5.3.7 Feeder Cork Pad Replacement
The cork pad located on the feeder table should not need cleaning; however, it may wear over
time and require replacement for optimal feeding performance (for more information about the
cork pad, see 1.4.1 Scanner Front - “
Cork Pad” on page 6).
Item(s) Needed
•New cork pad
To replace the cork pad, perform the following:
1. Power OFF the scanner (see 1.4.2 Scanner Back, “
Power Switch” on page 11)
Feeder Table
Feeder Sensor
Cork Pad
Separator
Roller Door
To Next Page
Loading...
