S008769 Rev A 53
Scanner Options
Scanner Options
This section identifies Ngenuity scanners’ two available options: Imprinters (front and back); and
SCSI connection type.
4.1 Imprinter
Both front page (pre-scan) and/or back page (post scan) imprinters are available for purchase to
use with Ngenuity scanners. These user-installable imprinters (same model/part number used for
front page and back page) include a circuit board that controls an ink-jet print head that imprints a
string of alphanumeric characters on documents as they pass through the scanner’s transport.
N
OTE
To purchase an Ngenuity Imprinter Kit, contact BBH Sales at 1-800-SCAN-494, go to the BBH
web store
, or contact a BBH Authorized Spare Parts Reseller (ASPR). A list of ASPRs is
available on the BBH web site - www.bbscanners.com
. Imprinter kits will be available after the
initial launch of the Ngenuity scanner.
The same imprinter is used for both the front page (pre-scan) and back page (post-scan)
imprinting; therefore, there is only one imprinter kit (part number: ACC1300).
For imprinter Installation and Operating instructions, see Appendix A (to be included in Rev B
and newer of this manual).
4.2 SCSI Connection
The Ngenuity scanner is equipped to accommodate a SCSI connection for communication
between the scanner and host PC. The optional SCSI connection can be used in lieu of the
standard USB connection.
N
OTE
The SCSI and USB connection types cannot be used simultaneously.
To use a SCSI connection, a SCSI card and cable is required. BBH does not provide a SCSI card
or cable with the Ngenuity scanner; therefore, these items must be purchased separately. A
SCSI connection kit is not available through BBH; however, BBH has certified that Adaptec’s
29160 LP or regular profile card is compatible with Ngenuity scanners. The SCSI cable must be a
D68-pin SCSI-3 cable.
To Next Page
Loading...
